Webinar:
How to Create Offset Layers Splits and Plies
Composite Flat is always accurate 3D to 2D flattening . This video illustrates the second workshop out of 3 on using Composite Flat for 3D to 2D Flattening of complex double curved surfaces. This video presents Piece Creation workflow, how offset layers are construct, and the split lines creation. At the end of the video you will be able to complete the workflow of flattening curved surfaces.
Table of Contents
Here’s the table of contents to the “How to Create Offset Layers, Splits and Plies” video. This video shows how the offset layers, splits and plies are created on on front fender motorcycle model. Use the links below to navigate to the section of interest or watch the entire video:
29:26 Add Grain Line
31:18 The Optimizer
35:43 Create a DXF File
37:54 Recap – Create an Offset
38:31 Recap – Rearrange a Construction Plane
39:10 Create Cutting Curves
42:08 Split the Layers
42:53 Change Layer’s Name and Color
44:55 Separate the Layers
45:13 Validate the Meshes
46:27 Adaptive Remesher
46:44. Flatten the Pieces
46:59 Pre-Flatteners
47:14 Arrange Pieces
47:46 Add Grain Line
48:20 The Optimizer
50:52 Create a DXF File
0:00 Introduction
0:35 Recap of 3D to 2D patterning Process
1:01 The Adaptive Remesher
1:57 Flatten the Pieces
2:26 Pre-Flatteners
3:02 The Optimizer
5:22 Create a DXF File – Add a Grain Line
6:07 Create Offset Layers
7:24 Offset your Mesh
9:24 Split Layers Into Different Plies
10:39 Create a New Construction Plane
11:55 Create Cutting Curves
15:30 Split the Layers
17:33 Change Layer’s Name and Color
22:38 Adaptive Remesher
26:19 Flatten Pieces
27:32 The Pre-Flatteners
27:59 Arrange Pieces
